Overhead Crane Certification Training Seminars

Overhead Crane Certification training seminar

Bridge Single and Double

Top or Under Running

Gantry

Wall Mount

All Hoists

Chain
Wire Rope
Roller Chain

Subjects Covered

Crane Capacity
Static to Dynamic loads
Two Blocking
Boom Deflection
Dynamic Loading
Dynamic Unloading
Side Loading
Power failure operating procedures
Critical lift criteria and compliance requirements

RULES GOVERNING PERSONNEL THAT USE OVERHEAD CRANES & HOIST IN ADDITION RIGGING EQUIPMENT REQUIREMENTS EQUIPMENT :OVERHEAD HOIST & OVERHEAD CRANE: BRIDGE SINGLE & DOUBLE, TOP OR UNDER RUNNING, GANTRY,WALL MOUNT ALL HOISTS CHAIN, WIRE ROPE, ROLLER CHAIN 1926.550(d)(4)

All overhead and gantry cranes in use shall meet the applicable requirements for design, construction, installation, testing, maintenance, inspection, and operation as prescribed in the ANSI B30.2.0-1967, Safety Code for Overhead and Gantry Cranes.

1910.179(a)(35) "Designated" means selected or assigned by the employer or the employer's representative as being qualified to perform specific duties.

1910.179(b)(8) Designated personnel - Only designated personnel shall be permitted to operate a crane covered by this section.

The Consensus Standards listed below are the primary resource for OSHA 5A1 violation, as well as used in litigation. ASME B30.2 Operators shall be required by the employer to pass a written ASME B30.7 or oral examination and a practical operating examination ASME B30.17 unless able to furnish satisfactory evidence of qualifications and experience. Qualifications shall be limited to the specific type of equipment for which examined.